PowerClean Poultice is a new technology, neutral pH powder with incredible stain absorption properties and non-scratch abrasives. Ideal for use in poultice form for lifting stains from porous surfaces. Provides revolutionary stain absorption properties for lifting stubborn deep-set stains from porous surfaces.
Colour: White powder pH: 9.2 (1% solution)
Safety: Non Hazardous Pack Size: 350g, 4kg, 7kg
BENEFITS
Conveniently Versatile – PowerClean Poultice is an inert, pH neutral
absorption powder and can be mixed with any cleaning
liquid to form a poultice. Compatible with solvents, alkalis & acids.
Substrate Safe – PowerClean Poultice is safe to use on all tile, stone, grout, masonary and cement surfaces, including sensitive polished granite, marble and limestone
Lifts Deep-Set Stains – A combination of revolutionary penetrating compounds and absorption agents provide unparalleled lifting action and removal of deep-set oily stains.
A Cleaning Booster – Specialty non-scratch abrasives are included for additional cleaning power on grout haze cleaning, porcelain wax removal and tough soil build ups.
SUBSTRATES
Safe for use on all hard surfaces including fine stone.
HOW TO USE
Read and understand the Material Safety Data Sheet (MSDS) before use
Always pre-test in an inconspicuous location before use to check for chemical sensitivity.
Poultice Form:
1. Mix PowerClean Poultice with TileClenz or Replenish to form a toothpaste consistency paste.
2. Cover oil stain with a 2-4mm thick layer of PowerClean Poultice /TileClenz poultice.
3. Allow to sit for a minimum of 30 minutes or until dry. Cover with plastic or similar to prevent direct exposure to sunlight and to prolong drying times.
4. Rinse or brush away.
Scouring Use:
1. Mix PowerClean Poultice with TileClenz Ultra to form a wet paste.
2. Use this paste to remove grout smear, cement, residues or tough, compacted grime build-ups. Scrub with a nylon pad.
3. Rinse well with water after use.
• Alternatively; apply the relevant cleaning solution to the floor area concerned and sprinkle sufficient Actisorb onto the area to form a slurry. Agitate using a low speed scrubber using a red pad or brush. Extract the slurry and rinse well with water.
|
